29
EN
P90-20191122A
WARNING! Cressi Sub S.p.A. strongly recommends that you
consult the data provided by the DIGI 2 console frequently during
your dive. Conditions such as temperature, any physical exertion
greater than a standard dive, or dives when under significant
emotional stress can significantly vary air consumption, and divers
can only prevent potential problems by carefully and frequently
checking this information.
WARNING! When the “replace” low battery warning appears,
replace it with a new one.
SURFACE SCREEN (POST-DIVE)
When the dive is complete, two minutes after reaching the surface
(depth < 0.8 m), the DIGI 2 console switches back to surface mode
(see chapter SURFACE SCREEN [PRE-DIVE]). Thus it will show the
following information:
1. CURRENT CYLINDER PRESSURE (set in BAR or PSI)
2. CURRENT DEPTH (set in m or ft)
3. MAXIMUM DEPTH reached in the previous dive (set in m or ft).
1 second
5 seconds
To Next Page
Loading...
