p. 31
stereo input module
aux send features
The following descriptions apply to the stereo line input module when
configured for stereo operation.
see—mono input module for mono operation
aux send 1–6 controls
These knobs adjust the amount of signal sent the
AUX buses.
AUX 1–4 are fed from a summed-mono source. AUXES 5–6 are also fed
from this mono source, but can be switched to stereo operation.
see—stereo balance
aux 1-4, 5/6 pre-fader—PRE
The default signal source for the AUX SENDS is post-fader.These switches
select a pre-fader source for their respective auxes.The pre-fader signal is
derived post-mute and post-eq.
see—internal jumper options
Corresponding AUX SENDS are post-eq, post-mute and post-fader.
Corresponding
AUX SENDS are post-eq, post-mute and pre-fader.
stereo balance 5 and 6—
STEREO
AUX 5 and 6 are mono.
AUX 5 acts as a left and right level-control and AUX 6 acts as a left/right
balance-control.
2
To Next Page
Loading...
