p. 35
stereo input module
bus assignment features
peak indicator—PK
The input signal is monitored at several points throughout the chan-
nel.These points are the mic preamp, the EQ stage and the fader stage.
Overloads at any of these stages will cause the red peak-
LED
to light.
Then the channel gain should reduced.
signal level LED’s
These three LED's light up at +8—yellow, 0—green, and -6 dB—
green. This level range -6 to +8 is the optimum operating range.
Compressed or relatively constant signals should remain close to 0.
mono assignment—M
The input signal is assigned to the discrete mono bus. Left and right
signals are summed to make up the mono or center signal.
left/right assignment—
L/R
The stereo input signals are assigned directly to the main left and
right output buses.
The proportion of left vs. right can be adjusted by the
BALANCE control.
To Next Page
Loading...
