INFORMATION:
• The clock automatically changes from set-up mode to time mode if no keys are pressed
for 20 seconds.
• The alarm sounds for 2 minutes if no key is pressed to stop it.
SNOOZE FUNCTION
To activate the snooze function, please follow the steps below
• Press the key “SNOOZE
/
LIGHT “, while the alarm sounds, to activate the snooze function.
• If the snooze function is activated
, alarm symbol is flashing.
• The alarm repeat after 5 minutes.
• The snooze function can be stopped by pressing any key.
12/24 HOURS MODE
The time display can be in 12 (AM/PM）or 24 hours mode, please follow the manual set-up to
select
°C/°F TEMPERATURE DISPLAY
The temperature display can be in °C or °F, press “▼ “ to select in normal mode
MAX./ MIN. FOR THE INDOOR/OUTDOOR TEMPERATURE AND HUMIDITY
• Press “ ▲ “ to display indoor and outdoor max temperature and humidity,
• Press “ ▲ “ again to display indoor and outdoor min temperature and humidity
• Hold “ ▲ “ for more than 3 seconds to clear up the max./min.
TEMPERATURE ALERT SET-UP
• Hold “▼ “ to flash ON OF ,press “
▲“ or “ ▼” to select on/ off.
• Press “MODE “, the upper limit of outside temperature is flashing, use “
▲“ and “ ▼”to
set the maximum alert temperature.
• Press “MODE “, the lower limit of outside temperature is flashing, use “
▲“ and “ ▼” to
set the minimum alert temperature.
• If select OF, press “MODE “ until to quit the alert.
• When the alert is activated, the alert symbol will be shown.
.
TEMPERATURE ALERT ON/OFF
• Alert on: Temperature alert symbol shown in display
• Alert off: Temperature alert symbol goes out.
INFORMATION
• The set-up process cannot be completed if the maximum temperature selected is lower
than the minimum selected temperature.
• The minimum temperature selected must at least be 1°C below the maximum selected
temperature.
To Next Page
