Cresta DTX510 - Daily Alarm Setup; Daily Alarm On;Off

• In the standard mode, press and hold the key “MODE“ for 3 seconds.
• The display for the YEAR is flashing. Use “
▲ “ or “ ▼ “ to select the correct year.
• Press “MODE“ to confirm.
• The display for the MONTH is now flashing. Use “
▲ “ or “ ▼ “ to select the correct month.
• Press “MODE“ to confirm.
• The display for the DATE is now flashing. Use “
▲ “ or “ ▼ “ to select the correct date.
• Press “MODE“ to confirm.
• The display for the TIME ZONE is flashing. Use “
▲ “ or “ ▼ “ to select the correct time zone
(-12 to +12).
• Press “MODE“ to confirm.
• The 12/24 HOUR FORMAT is flashing. Use “
▲ “ or “ ▼“ to select
• Press “MODE“ to confirm.
• The LANGUAGE selection for the display of the WEEKDAYS is now flashing. Use “ ▲ “ or
“ ▼“ to select the language (EN - English, GE- German, SP - Spanish,IT - Italian, FR - French,
DU - Dutch, DA - Danish).
• The hPa/inHg for the air pressure is now flashing, Use “ ▲ “ or “ ▼“ to select .
• Press “MODE “ to confirm.
• The display for the HOUR is now flashing. Use “
▲ “ or “ ▼“ to select the correct hour.
• Press “MODE “ to confirm.
• The display for the MINUTES is now flashing. Use “
▲ “ or “ ▼“ to select the correct
minutes..
• Press “MODE “ to confirm.
INFORMATION:
• The clock automatically changes from the set-up mode to the time display mode if no
keys are pressed for 20 seconds.
• Explanation for the time zone display:
You can manually adjust the clock to the time zone of a country located up to 1500km
distance to Frankfurt/Main where the clock can still receive the DCF77 signal but where
the actual time differs from the time received.
If, e.g. the time in a given country is 1 hour ahead of the German time, set the time zone
display to 01. The clock is now DCF77 controlled but shows the time is one hour ahead.
DAILY ALARM SET-UP
• Press “MODE” to switch from time display to A1 display
• Press and hold the key “MODE” for 3 seconds, the flashing alarm time are shown
• The HOUR display of the alarm time is flashing. Use “▲ “ and “▼ “ to select the hour.
Press “MODE” to confirm.
• The MINUTES display is now flashing. Use “▲ “ and “▼ “ to select the minutes,
• Press “MODE” to confirm.
• The same setting as for A2.
DAILY ALARM ON/OFF
• Press “MODE” to switch from the time display to the “A1” or “A2” mode
• When the A1 or A2 alarm time is showing press “
▲“ or “ ▼ ” to activate the alarm with
the alarm symbol showing.
• Press“
▲“ or “ ▼ ” again to cancel the alarm