Crestron AMP-8075 User Manual

The Crestron® AMP-8075, AMP-8150, AMPI-8075, and AMPI-8150 are
high-efficiency multichannel power amplifiers offering excellent sound
quality. All four feature similar operation. For simplicity within this guide,
the term "amplifier" is used for all models except where noted.
In the Box
1 AMP-8075, AMP-8150, AMPI-8075, or AMPI-8150,
8-Channel Commercial Amplifier
Additional Items
2 Bracket, Rack Ear, 1U (2032122)
2 Bracket, Rear Mounting (2045677)
8 Connector, 2-Pin (2044402)
8 Connector, 3-Pin (2003575)
AMP-8075 and AMP-8150 Only
1 Fuse, 10.0 A, Time Lag, 1.25 in. x 0.25 in., Ceramic Cartridge,
250 V (2017577)
1 Cable, Power, 6 ft 7 in. (2001134)
AMPI-8075 and AMPI-8150 Only
1 Fuse, 6.3 A, Time Lag, 5 x 20 mm, Ceramic Cartridge,
250 V (2024846)
1 Cable, Power (P/N varies by country)
Install the Device
These devices occupy 1U of rack space.
To install the included rack ears:
1. Use a #1 Phillips screwdriver to remove the three screws from each
side of the front of the amplifier as shown in the following illustration.
2. Use the six screws removed in the previous step to attach the included
rack ears to the amplifier.
1
AMP(I)-8075 and AMP(I)-8150
QuickStart
Crestron® 8-Channel Commercial Amplifiers

Crestron AMP-8075 Specifications

General

Amplifier Class	Class D
Number of Channels	8
Power Output (8 ohms)	75 W per channel
Gain	32 dB
Weight	11.5 lb (5.2 kg)
Humidity	10% to 90% non-condensing
Frequency Response	20 Hz - 20 kHz
Total Harmonic Distortion (THD)	< 0.1%
Signal-to-Noise Ratio (SNR)	> 100 dB
Input Impedance	10 kΩ
Input Sensitivity	1.0Vrms (for full output)
Protection	Short circuit, DC offset
Power Requirements	100-240 VAC
Operating Temperature	32°F to 104°F (0°C to 40°C)