Crestron HD-DA2-4KZ-E User Manual

Quick Start
The HD-DA2-4KZ-E, HD-DA4-4KZ-E, and HD-DA8-4KZ-E distribution amplifiers split a single
HDMI® signal to feed up to two, four, or eight displays and other device types, respectively.
The distribution amplifiers support UHD and DCI 4K60 4:4:4 HDR video, HDCP 1.4 or 2.2 copy
protection, and high-bitrate 7.1 audio. No control system is required for operation.
Check the Box
Item Qty
HD-DA2-4KZ-E, HD-DA4-4KZ-E, or HD-DA8-4KZ-E 1
Power Pack, 24 Vdc 0.75 A, 100-240 Vac (P/N 2045865) 1
Install the Device
The distribution amplifiers can be mounted onto drywall or onto a rack rail.
Drywall Mounting
Using four 8-18 x 3/4" modified truss head Phillips steel screws (not included), mount the
device onto drywall.
Drywall Mounting (HD-DA2-4KZ-E Shown)
(4) Screws, 8-18 x 3/4” modified
truss head Phillips, steel (not
included)
Drywall
Rack Rail Mounting
Mount the device onto the front or rear rail of a rack. Position either the left or right
mounting flange of the device so that the holes align with the holes in the rack. Then, secure
the device to the rack using two rack mounting screws (not included). For more information,
refer to the mounting instructions of the rack manufacturer.
Rack Rail Mounting (HD-DA2-4KZ-E Shown)
Screws
(not included)
Connect the Device
Connect the rear panel of the device as required for the application.
Rear Panel Connections (HD-DA2-4KZ-E Shown)
INPUT:
From HDMI®
audio/video
source
OUTPUT 1:
To HDMI
display
OUTPUT 2:
To HDMI
display
SERVICE:
For
firmware
loading
24 V 0.75 A:
From
included
power pack
HD-DA2-4KZ-E, HD-DA4-4KZ-E, and HD-DA8-4KZ-E
Distribution Amplifiers

Crestron HD-DA2-4KZ-E Specifications

General

Brand	Crestron
Model	HD-DA2-4KZ-E
Category	Amplifier
Language	English

Summary

Distribution Amplifiers Quick Start

Check the Box

Lists the items included in the product package for initial setup.

Install the Device

Instructions for mounting the distribution amplifiers onto drywall or a rack rail.

Drywall Mounting

Details on mounting the device onto drywall using screws.

Rack Rail Mounting

Procedure for securing the device to a rack using mounting screws.

Connect the Device

Guidance on connecting the rear panel of the device for operation.

Device Configuration

Select the EDID Mode

Configure the EDID (Extended Display Identification Data) mode using the EDID switch.

Select the HDCP Version

Set the HDCP (High-bandwidth Digital Content Protection) version via the HDCP switch.

Observe the LEDs

Information on interpreting the status indicators on the device's front panel.

Additional Information

Links and resources for obtaining detailed product information.

Compliance and Legal

Details on product compliance, safety certifications, and legal statements.