DO GUIDE
DO Connect the Device
Connect the device as required for the application. Refer to illustration .
Connecting the Device
For information about VGA IN connector pin assignments, refer to illustration . For information
about DM OUT wiring, refer to illustration . For information about LAN connector pin
assignments, refer to illustration .
DM-TX-4K-202-C/DM-TX-4K-302-C
4K DigitalMedia 8G+
®
Transmitters
DO Install the Device
The Crestron
®
DM-TX-4K-202-C and DM-TX-4K-302-C can be mounted onto a at surface or
onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface such as a wall
or a ceiling. Refer to illustration .
Mounting onto a Flat Surface
Mounting onto a Rack Rail
The DM-TX-4K-202-C and DM-TX-4K-302-C mount onto the front or rear rail of a rack. Position
either the left or right mounting ange of the device so that the holes align with the holes in the
rack. Then, secure the device to the rack using two rack mounting screws (not included).
Refer to illustration .
Mounting onto a Rack Rail
DO Check the Box
QTY PRODUCT PART NUM.
1 Connector, 2-Pin 200 3574
1 Connector, 5-Pin 2003577
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac 2045865
Not Included: Cables, Mounting Screws
HDMI
®
Digital Video
and Audio Inputs
Unbalanced Stereo
Line Level
Audio Input*
To DM
®
Switcher,
Receiver, or Other
DM Device or to
HDBaseT
®
Device
RGB (VGA), Component,
S-Video, or Composite
Video Input*
24 VDC from
Power Pack
(Included)
From USB Host
Interface of USB HID
Compliant Host Device
HDMI Digital Video
and Audio Output
To IR Controllable
Device
10BASE-T/100BASE-TX
Ethernet to Source
Device†
To/From RS-232 Device
Mouse/Keyboard
Input
*Available on the DM-TX-4K-302-C only
†
Do not connect the LAN port to an Ethernet switch if the DM OUT port connects to a DM switcher. If the DM OUT port does not connect to a DM switcher, the LAN port can
connect to an Ethernet switch.
To Next Page
Need help?
General
