FlipTop Touch Screen Crestron FT-TS600
4 • FlipTop Touch Screen: FT-TS600 Operations & Installation Guide – DOC. 7585B
Power over Ethernet
Using PoE+ technology, the FT-TS600 gets its operating power right through the
LAN wiring. PoE eliminates the need for a local power supply or any dedicated
power wiring. A PoE+ capable power source (CEN-SWPOE-16, sold separately, or
similar) is required to power the FT-TS600.
Specifications
Specifications for the FT-TS600 are listed in the following table.
FT-TS600 Specifications
SPECIFICATION DETAILS
Touch Screen Display
Display Type TST active matrix color LCD
Size 5 inch (127 mm) diagonal
Aspect Ratio 15:9 WVGA
Resolution 800 x 480 pixels
Brightness 300 nits (cd/m
)
Contrast 450:1
Color Depth 24-bit, 16.7 million colors
Illumination Edgelit LED
Viewing Angle ±69º horizontal, +62º /-64º vertical
Touch Screen Projected capacitive
Buttons
Hard Keys (5) Projected capacitive push buttons,
programmable, pre-labeled with icons
for “Power”, “Home”, “Lights”, “Up”, and
“Down”
Memory
DDR3 SDRAM 1 GB
Flash 4 GB
Maximum Project Size 512 MB
Graphics Engine Supports Smart Graphics*
Communications
Ethernet 10/100 Mbps, auto-switching,
auto-negotiating, auto-discovery,
full/half duplex, DHCP, IEEE 802.3at
Type 2 compliant
Video
Streaming Formats H.264 (MPEG-4 part 10 AVC), MJPEG
Audio
Features Built-in microphone and speaker, Rava
SIP Intercom, line out (same signal as
speaker)
Audio Feedback Format MP3
Power Requirements
Power over Ethernet IEEE 802.3at Type 2 Class 4 PoE+
powered device
(Continued on following page)
To Next Page
Loading...
