Crestron RFID-USB User Manual

The Crestron® RFID-USB is an RFID card reader that integrates into
supported room scheduling applications and custom room control
projects via a TSW-70 series or TSS-70 series touch screen. The
RFID-USBinstallsnexttothetouchscreen,allowing users to easily
authenticate with or communicate to the touch screen by scanning an
RFIDcard.TheRFID-USBalsointegrateswithaCrestroncontrol system
for custom room control or access projects.
NOTE:Athird-partyQuickStartisprovidedintheboxwiththe
RFID-USBforcompliancepurposesonly.TheCrestron Quick Start
should be used when installing the RFID-USB.
In the Box
1 RFID-USB, RFIDCardReader
Additional Items
4 Adhesive Pads (2058188)
1 Cable, Micro USBtoUSBA, 17.72 in. (450 mm)(2058186)
1 Frame, Glass Mount (2058187)
1 Label, Adhesive (2058189)
Install the RFID-USB
The RFIDcanbeinstalledintodrywallorontoaflat,smoothsurface
such as glass. Procedures for each installation are provided in the
sections that follow.
NOTE:ToavoidRFinterference,ensurethatnometalobject or surface
is located within 10 cm of the RFID-USB after installation
Drywall Mounting
The following is required for this installation: a level, a roll of masking
tape, a drill, and a surface cleaning product that does not leave a film.
NOTE:Thefollowingprocedureassumes that the touch screen has
been installed into drywall using its provided mounting bracket or the
TSW-770/1070-MSMK-ANG multisurface mount kit. For more
information, refer to the TSW-570,TSW-770,andTSW-1070 Quick
Start, the TSS-770 and TSS-1070 Quick Start, or the
TSW-770/1070-MSMK-ANG Quick Start.
1. Clean and dry the mounting surface thoroughly.
2. Select the mounting location for the RFID-USB. The RFID-USBshould
be mounted below the touch screen and should not be mounted more
than 8in.(203mm)awayfromthetouchscreen.
3. Using the level, tape a horizontal reference line on the mounting
surface that aligns with the lower edge of the RFID-USB. Ensure the
reference line is level before proceeding.
4. Drill a 3/4in.(19mm)diameter hole into the mounting surface at the
center of where the RFID-USB will be mounted.
5. Route the provided USBcablethroughthedrywallfromthetouch
screen cutout to the hole created in step 4 above. Ensure that the
micro USBendofthecableisroutedtothemountinglocation.
6. Attach the USBAcableendtothetouchscreenrearhousing.
RFID-USB
QuickStart
RFIDCardReader
1

Crestron RFID-USB Specifications

General

Brand	Crestron
Model	RFID-USB
Category	Rfid Systems
Language	English