Crestron RFID-USB - Attach the Label (Optional)

14. Once the RFID-USB is level and aligned with the taped reference line,
press the edges of the device to the mounting surface firmly to
ensure proper adhesion and to eliminate any trapped air bubbles.
Attach the Label (Optional)
To provide a finished appearance for installations on glass or other
transparent surfaces, install the included adhesive label on the opposite
side of the surface behind the RFID-USB.
To install the label:
1. Clean and dry the rear of the mounting surface thoroughly.
2. Using the level, tape a horizontal reference line on the glass surface
that aligns with the lower edge of the RFID-USB on the opposite side.
Ensure the reference line is level before proceeding.
3. Remove the protective liner from the rear of the label.
CAUTION: The adhesive on the rear of the label is high-strength
bond. Once the adhesive comes in contact with a surface, it cannot
be removed easily.
4. Hold the label at a 45-degree angle to the RFID-USB, and then align
the lower edge of the label with the lower edge of the RFID-USB. Do
not allow the label adhesive to come in contact with the surface.
5. Once the label is level and aligned with the angled bracket, press the
label to the pad firmly to ensure proper adhesion and to eliminate
any trapped air bubbles.
7
RFID-USB
QuickStart
RFIDCardReader