CrimeStopper Cool Start RS-3 - User Manual

RS-3 and RS-4
1-WAY REMOTE START SYSTEM
OPERATING INSTRUCTIONS
CONGRATULATIONS on your choice of a Cool Start™ Remote Engine Starter and Keyless Entry with DP
Technology by Crimestopper Security Products Inc. This booklet contains the information necessary for operating
your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, and Brake Reset. For programming, the hood pin and program button are
required.
-OPTIONAL: These features are to be connected only if desired or agreed upon by the customer and the installing
dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features may also
require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is going to be
installed with your particular system.
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV B 11-2008
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.

Summary

OPERATION CAUTIONS & WARNINGS

Manual Transmission Warning

Critical safety warning against installing on manual transmission vehicles.

Garage Operation Warning

Warning about potential CO poisoning when starting in closed garages.

USING THE REMOTE TRANSMITTER

REMOTE ENGINE CONTROL - BUTTON SELECTION

Button Press Selection (Option #6)

Options for activating remote starter and trunk release via button presses.

REMOTE ENGINE CONTROL - STARTING

Successful Start Procedure

Step-by-step process for a successful remote engine start.

Unsuccessful Start Attempts

REMOTE ENGINE CONTROL - IDLE DOWN

Idle Down Mode Operation

REMOTE ENGINE CONTROL - ADVANCED MODES

Infinity Run Mode

Selectable Hourly Cold-Start

System self-starts at hourly intervals for cold weather protection.

TURBO TIMER MODE (OPTION #22)

Brake Pedal Set Mode

Always Set Mode (Default)

Idle Down Mode for Turbo

CONVENIENCE AND SAFETY FEATURES - SECURITY & MODES

Valet Mode and Starter Disable

Disables remote start function for vehicle servicing.

Anti-Grind;Starter Disable

Hood Open Safety

Prevents remote start if the vehicle hood is open.

Brake Pedal Reset Function

Shuts down remote-started engine when brake pedal is pressed.

TRANSMITTER PROGRAMMING

Learning Transmitter Codes

Process for programming remote transmitter codes to the system.

2-VEHICLE OPERATION & PROGRAMMING

Remote Control Setup for Two Vehicles

Instructions for programming a single remote to control two vehicles.

REMOTE START DIAGNOSTICS

Parking Light Flash Codes

Interprets parking light flashes as diagnostic error codes.

2-Way DATA PORT

Databus Module Integration

CrimeStopper Cool Start RS-3 Specifications

General

Type	Remote Starter
Range	Up to 1500 feet
Keyless Entry	Yes
Number of Buttons on Remotes	4
Engine Start	Yes
Security System	No
Installation Required	Yes
Security Features	Starter Kill
Compatibility	Gasoline vehicles
Programmable Options	Yes, multiple programmable features