Criterion 681-4009 - Dishwasher Connection; Electrical Connection & Grounding

9 CONGLOMKB.COM
Please contact cs@conglomkb.com or 1-888-449-9194 for further assistance.
Installation (continued)
Turn the bottom supporting ring 1/3 of a turn counter-
clockwise and repeat the mounting procedure described
above (see Fig 13).
1/3 turn
Fig. 13c
- Connect the bottom of the elbow to the trap by
tightening the slip nut (Fig. 14).
- Run water and check all connections for leaks.
Fig. 14
DISHWASHER CONNECTION
Fig. 15
*
Air Gap
Drain
Disposer
Rubber Hose
Dishwasher Hose
- Connect the dishwasher hose (see Fig. 15) using a
hose clamp. Make sure all plumbing connections are
tight. Run water and check for leaks.
*Air Gap may not be required for all installations, verify
your local plumbing codes.
ELECTRICAL CONNECTION & GROUNDING
- Connect the disposer to the appropriate household
current only.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. Check with a qualied electrician
or serviceman if you are not sure. Do not modify
the plug provided with the appliance if it does not
t the outlet. Have a proper outlet installed by a
qualied electrician.
NOTE: The waste disposer plug provided needs
to be controlled by an on/off switch (usually wall-
mounted).
- This appliance must be grounded. In the event of a
malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the
risk of electric shock. This appliance is equipped with a
cord having an equipment-grounding conductor and a
grounding plug. The plug, supplied with this unit, must
be connected to an appropriate outlet that is properly
installed, switched and grounded in accordance with
all local codes and ordinances. If the supply cord is
damaged it must be replaced by the manufacturer or a
qualied person in order to avoid a hazard.