4. Put the bobbin onto the bobbin spindle (30)
so that the end of the thread is on top of the
bobbin. Push the bobbin spindle to the right
towards the bobbin winder pulley (29) until it
clicks.
Hold the end of the thread and activate
the foot controller. As soon as a bit has been
wound upon the bobbin, release the end of
the thread.
Keep winding until the bobbin spindle is
automatically stopped.
5. Push the bobbin spindle to the left and take
off the bobbin.
Cut off the thread.
6. Push the balance wheel (28) back again,
as far as it goes.
Now the needle will move again, when
the foot controller is activated.
7. You can regulate the height of the bobbin-
winding thread guide should the thread be
wound unevenly.
- Open the front cover (see page 7)
- Loosen screw (A) to regulate the height of the
bobbin-winding thread guide (B).
4
5
6
7
15
A
B
Bobbin-winding
thread guide
To Next Page
Loading...