Reverse sewing is used at the beginning and
end of a seam for reinforcement.
- Press the reverse sewing lever (5)
down and keep it pressed.
- Activate the foot controller - the more you
press the foot controller, the faster the
machine runs.
- If you want to return again to sewing forward,
release the reverse sewing lever.
For sewing buttons, hooks, eyelets and for
stitching of monograms, it is important that the
material will not automatically be fed, but that you
can control the feeding of the material yourself.
In this case you must attach the darning plate.
First lift the presser foot lever (23) and move up
the needle to its highest position by turning the
balance wheel (28).
1. 2. Now press the two pins of the darning
plate into the respective openings of the
throat plate (9), until it snaps into place,
as shown in figures 1 and 2.
The darning plate can be removed again
by raising it at the edges.
Reverse sewing
Attaching the darning plate
23
To Next Page
Loading...