3.
Put the thread under the front thread guide (10),
and pull the end of the thread upward. The
inner small wire spring (A) will automatically
be lifted, as shown.
4. Lead the thread from right to left through the
hook of the thread take-up (2).
5. The thread will then be led through the
internal thread guide (B, figure 3) and finally
through the thread guide of the needle bar
thread guide (13).
Pull out approx. 10 cm of thread from the
front to the back through the eye of the
needle.
17
3
4
5
A
B
To Next Page
Loading...