Sewing buttonholes (continued)
36
1. Set the program selection (3) to (18).
Then lead the upper thread through
the opening of the buttonhole foot and draw
both threads, the upper and the under thread,
to the left side. Lower the presser foot and
proceed to sew slowly until you have reached
the desired length, at the end (A).
2. Raise the needle to its highest position
and set the program selection to (19).
Thereafter, you sew a few stitches of the bar
on this side (B).
3. Raise the needle to its highest position
and set the program selection to (20).
Then you proceed to sew to right side (C) of
the buttonhole, over the same length,
as on the left side.
4. Raise the needle to its highest position
and set the program selection to (19).
Thereafter, you sew a few stitches of the
upper bar at the end (D).
For knotting the threads together, set the
stitch length dial to ‘O’ and sew a few
stitches.
5. Then the buttonhole has carefully to be cut
open by using the ripping knife. Be
careful not to damage the buttonhole bars.
1
2
4
3
5
To Next Page
Loading...