11
Connecting Optional Equipment
1 You can connect external components to your
unit by using the Auxiliary Input.
2 Plug Auxiliary cable into the LINE IN JACK (32)
on the back of your unit.
3 Switch the LINE IN SWITCH (31) to the ON
position.
4 Plug the other end of the Auxililary cable into
the output jack on your desired external
component.
5 Check the volume level of your external
component.
6 See operators manual for correct operation of
the external component.
NOTE: When not using the Auxiliary Input, make
sure the LINE IN SWITCH (31) is in the
OFF position.
Auxiliary Input
There is no Power
1 Make sure the radio is plugged in correctly.
2 Check to see that the power button is
pushed in.
There is no Sound
1 Check the volume level by turning the volume
knob.
2 Make sure the Line In Switch is in the off position
if not using the Auxiliary Input.
Turntable will not work
1 Make sure the function switch is set to phono.
2 Try moving the tone arm to the right until you
hear a click.
3 Make sure the protective needle cover is
removed.
CD does not play
1 Check to make sure CD is inserted correctly
(label side facing up).
2 Check that the surface of the CD is clean
3 Make sure function switch is set to CD.
Troubleshooting
To Next Page
Loading...
