Crossfire CFS10 - Deactivating the CFS10 Smoke Alarm; End-of-Life Deactivation Process

11
O
F
F
Deactivating the CFS10 Smoke Alarm
When the alarm’s End-of-Life signal occurs, the alarm must be deactivated and
disposed of properly. Be sure and have a replacement alarm available.
To deactivate the alarm, insert a pin or bent
paperclip into the deactivation lock-out hole.
Hold the pin down firmly.
When the switch is fully positioned the word
“OFF” will be exposed.
The switch will lock permanently into place.
The alarm cannot be reactivated!
After the deactivation switch has been thrown,
the WARNING light will turn on. This will
deplete any remaining battery power over a
period of a few hours.
After the light has gone out, responsibly dispose
of the alarm and replace with a new smoke
alarm!
With the pin still pressed firmly in place, slide the
switch in the direction indicated by the arrow in
the drawing.
If the alarm’s End-of-Life signal has begun,
remove the alarm from its bracket.
Locate the slide switch and the deactivation
lock-out hole on the back surface of the alarm.
slide
switch
lock-out hole