To Next PageTo Next Page
Need help?Do you have a question about the Crown 800CSL and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Power Output at 4Ω | 800W |
| 8 Ohms Per Channel | 200W |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | < 0.05% |
| Input Sensitivity | 1.4V |
| Signal-to-Noise Ratio | >100 dB |
| Damping Factor | >200 |
| Dimensions | 19" x 3.5" x 15.2" (48.3 cm x 8.9 cm x 38.6 cm) |
| Weight | 38 lbs (17.2 kg) |
| Voltage | 120V |
| Input Impedance | 20kΩ |
Describes the manual's content and warranty policies.
Explains part numbering systems, types, and how to order.
Details power ratings, AC mains, performance, and protection systems.
Covers general amplifier overview, key features, and input signal processing.
Describes the error amp, voltage translators, and last voltage amplifiers.
Explains the unique grounded bridge output stage design and its operation.
Details the ODEP protection circuitry and its function.
Covers general information, initial conditions, and basic tests like DC offset.
Procedures for measuring DC offset and adjusting output bias.
Procedure for ODEP voltage calibration.
Covers AC power draw, CMR, voltage gain, phase response, level controls, and crosstalk tests.
Covers current limit, slew rate, output power, and reactive loads tests.
Covers ODEP limiting, LF protection, signal-to-noise, and transient tests.
Covers intermodulation distortion and clipping tests.
Describes returning amplifier controls to factory default settings after testing.
Lists supplemental items and parts specific to North American voltage.
Lists parts for fanformer, filter capacitor, fuse board, and LED assemblies.
Lists components for the output assembly and back panel.
Lists components for the front chassis assembly.
Lists hardware and components for the main chassis assembly.
Provides historical context and lists output and main module types.
