Crown CDi 4000 - Page 5

page 8
CDi Series Power Amplifiers
Operation Manual
CDi Series Power Amplifiers
Operation Manual page 9
Channel 2
Channel 2
Channel 1
Channel 1
Figure 2.5 System Wiring,
Dual Mode
2 Setup (continued)
2 Setup (continued)
Channel 1
2.6.2 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 2.6.
NOTE: Crown provides a reference of wiring pin assignments
for commonly used connector types in the Crown Amplifier
Application Guide available at www.crownaudio.com.
OUTPUTS: Connect the speaker across barrier-strip
terminals 1+ and 2+.
IMPORTANT: Set the Bridge/Normal switch in the
LCD screen to “Bridge.” See Section 4.1.5.
NOTE: In Bridge-Mono mode, only the
Channel 1 Level control is functional (unless you
make an alternate selection via the “Y” menu. See
Section 4.1.6.)
2.6 Wire Your System
2.6.1 Dual Mode
Typical input and output wiring is shown in Figure 2.5.
INPUTS: Connect input wiring for both channels.
OUTPUTS: Maintain proper polarity (+/–) on output
connectors.
Connect Channel 1 loudspeaker’s positive (+) lead to
Channel 1 positive (+) terminal of amp; repeat for negative
(–). Repeat Channel 2 wiring as for Channel 1.
Figure 2.6 System Wiring,
Bridge-Mono Mode