J
Jose MooreJul 26, 2025
What to do if Crown CDi 6000 doesn't turn on?
- PPaul HoffmanJul 26, 2025
If your Crown Amplifier isn't turning on, make sure that the amplifier’s Power switch is on and the amplifier’s power cord is plugged in.
To Next PageTo Next PageWhat to do if Crown CDi 6000 doesn't turn on?
If your Crown Amplifier isn't turning on, make sure that the amplifier’s Power switch is on and the amplifier’s power cord is plugged in.
Why is my Crown CDi 6000 sound distorted?
Distorted sound from your Crown Amplifier can occur if the input signal level is too high. To resolve this, turn down your amplifier's Level controls.
General| Channels | 2 |
|---|---|
| 8 Ohm Stereo (per channel) | 600W |
| Total Harmonic Distortion (THD) | < 0.5% |
| Frequency Response | 20Hz - 20kHz, +0/-1 dB |
| Signal to Noise Ratio | >100 dB |
| Input Sensitivity | 1.4V |
| Input Impedance | 20k Ohm |
| Connectors | Input: XLR, Output: Binding Post |
| Cooling | Variable speed fan |
| Height | 3.5 in (8.9 cm) |
| Width | 19 in (48.3 cm) |
| Damping Factor | >500 |
Details FCC compliance, operational conditions, and interference correction measures.
Lists key features of the Crown CDi Series amplifiers.
Provides guidance on using the operation manual effectively.
Instructions for unpacking and inspecting the amplifier for transit damage.
Steps for installing the amplifier in a rack or stacking setup.
Guidelines for maintaining adequate airflow and ventilation for the amplifier.
Guidance on selecting appropriate input wiring and connectors.
Recommendations for selecting speaker wire and connectors based on distance.
Instructions for wiring the amplifier system.
Details on wiring the amplifier for dual-channel stereo operation.
Instructions for wiring the amplifier in bridge-mono mode.
Procedure for connecting the amplifier to the AC power source.
Advice on preventing speaker damage, including avoiding amplifier clipping.
Step-by-step guide for safely turning on the amplifier for the first time.
Essential precautions for optimal performance and safety during operation.
Description of front panel controls, buttons, and indicator LEDs.
Details the back panel connectors for CDI 1K, 2K, and 4K models.
Details the back panel connectors for the CDI 6K model.
Overview of the amplifier's extensive protection and diagnostic capabilities.
Protects amplifier output stage from short-circuit loads.
Shuts down amplifier on output DC offset exceeding 2V.
Activates if heatsink temperature exceeds operating limits.
Provides a shock-proof cover for the amplifier output terminals.
Security covers to prevent unauthorized changes to output level controls.
Details how to select and configure DSP presets and processes.
Information on obtaining service outside the United States.
Procedures and requirements for obtaining service within the United States.
Covers the scope of the 3-year warranty, exclusions, and remedies.
Details the process for obtaining warranty service in the US and Canada.
Covers warranty alterations, design changes, and legal remedies.
