Crown XLS 1502 - System Configuration Examples; Monaural Bi-Amp System Setup; Stereo Bi-Amp System Setup

XLS DriveCore 2 Series Power Amplifiers
page 9
Operation Manual
Crossover Mode
Stereo Bi-Amp System
A theater 2.1 sound amplification system can be easily set up using one amplifier in STEREO mode for the L and R channels and a second amplfier in BRIDGE mode with a
Low Pass filter set to the appropriate cutoff frequency.
Monaural Bi-Amp System
1. Configure the system as described in Input-Y section on page 8. The
woofer connected to Channel 1 and the mid/high drivers to Channel 2.
2. Set up Channel 1 as a Low Pass filter and use your crossover frequency as
the filter's cutoff frequency.
3. Set up Channel 2 as a High Pass filter using the same filter cutoff
frequency as in Step 2 above.
System Conguration Examples