Need help?Do you have a question about the Crown XLS1000 and is the answer not in the manual?
General| Damping factor | 200 |
|---|---|
| Amplifier class | D |
| Frequency range | 20 - 20000 Hz |
| Audio output channels | 2.0 channels |
| Peak power per channel | - W |
| Signal-to-Noise Ratio (SNR) | 97 dB |
| Total Harmonic Distortion (THD) | 0.5 % |
| Bridge-mode power output per channel (4 Ohm) | 1100 W |
| Bridge-mode power output per channel (8 Ohm) | 700 W |
| AC (power) in | Yes |
| Speakers connectivity type | XLR / 1/4\ |
| Purpose | - |
| Product color | Silver |
| Connectivity technology | Wired |
| Maximum current | 15 A |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| LED indicators | Activity, Power |
| Package weight | 6200 g |
Weight and Dimensions| Depth | 196 mm |
|---|---|
| Width | 483 mm |
| Height | 89 mm |
| Weight | 3900 g |
Explains amplifier audio routing options like STEREO, BRIDGE, INPUT Y.
Describes audio filtering options like BYPASS, LOWPASS, HIGHPASS.
Displays the amplifier's model and AC input voltage.
Shows power supply heatsink temperature and low voltage rail.
Displays heatsink temperature for each channel's power devices.
Indicates positive (VP) and negative (VN) amplifier voltage rails.
Shows the current firmware version.
Indicates the latest fault and its number of instances.
Internal MCU error like PLL.
Catastrophic firmware error.
Firmware error from watchdog timeout.
Power supply sequencing failure.
LCD initialization failure.
MCU unable to communicate with LCD.
MCU unable to boot DSP via I2C.
MCU failed to communicate with DSP.
Failure in DSP communication/control.
Unable to communicate with Ruby initially.
I2C communication failure with Ruby.
Illegal ADC value encountered by MCA via Ruby.
MFGTEST byte indicates test failure.
APM unable to communicate with MFG fixture GPIO.
APM unable to communicate with MFG fixture ADC.
Input signal path, gain stages, and routing.
Clock signal generation and distribution.
Describes digital audio data path and formats.
Microprocessor boot process and Power On Self-Tests.
Processor communication with Ruby IC via I2C.
Processor communication with DSP via I2C.
Interface between processor and LCD module.
Lists possible LCD error codes and their meanings.
Procedure for troubleshooting LCD problems using a scope.
Lists amplifier assemblies by model and description.
Lists relevant printed wiring assemblies (PWAs).
Lists auxiliary test assemblies and their descriptions.
Lists PWAs for XLS1000/1500 series.
Lists PWAs for XLS2000/2500 series.
To Next Page
