12
CONTROLS AND INDICATORS - ELECTRIC VEHICLES
See General Warnings on page 7.
WARNING
• If renting or loaning the vehicle, make sure the driver is familiar with all controls and operating procedures
before allowing the vehicle to be driven.
• Do not shift the Forward/Reverse switch while the vehicle is moving. To avoid injury to an unsuspecting
passenger or damage to the vehicle, always bring the vehicle to a full stop before shifting the
Forward/Reverse switch.
• Release the accelerator pedal and then press the brake pedal firmly until the vehicle stops. To avoid
unintentionally starting or rolling the vehicle, set the park brake, place the Forward/Reverse switch in the
NEUTRAL position, turn the key switch to the OFF position, and remove the key when leaving the vehicle.
KEY SWITCH
The key switch is mounted on the dash to the right of the steering column (Figure 7). It has two positions, OFF and ON,
which are clearly labeled. See following NOTE.
FORWARD/REVERSE CONTROL
The Forward/Reverse rocker switch is located on the seat support panel, below and to the right of the driver's
right knee (Figure 8). The F (FORWARD) and R (REVERSE) are clearly marked. Push down the FORWARD
side of the switch to operate the vehicle in the forward direction, or push down the REVERSE side of the switch
to operate the vehicle in reverse. When the rocker switch is positioned in the NEUTRAL position, with neither
side down, the vehicle will not operate if the accelerator pedal is pressed. The reverse buzzer will sound as a
warning when the Forward/Reverse switch is in the REVERSE position
To Next Page
Loading...