EasyManua.ls Logo

CRUISE CAR VECTOR - GASOLINE ENGINE OIL LEVEL CHECK PROCEDURE; LOCATING AND USING DIPSTICK

CRUISE CAR VECTOR
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
WARNING
If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do so
may cause them to overheat during operation and could result in fire, property damage, or personal injury.
Be sure battery clamp is properly tightened. Tighten to 144 in-lb (16 N-m). A loose battery clamp may allow the battery to
become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged any longer than
absolutely necessary (do not leave discharged overnight).
ENGINE OIL - GASOLINE VEHICLES
ENGINE OIL LEVEL CHECK
1. Remove the oil level dipstick from the oil filler tube, and wipe oil off dipstick (1) (Figure 39). See following
CAUTION.
CAUTION
• Do not remove dipstick while engine is running.
2. Check oil by fully inserting the dipstick into the oil filler tube (2) and immediately removing it.
3. If the oil level is at or below the low level mark on the dipstick gauge, add oil until the level is between low and full
levels (safe level) (3).
4. Insert the dipstick into the oil filler tube.
NOTE: Properly recycle or dispose of used oil in accordance with environmental laws.

Related product manuals