43
SINGLE POINT WATERING SYSTEM (SPWS)
CAUTION
• Water the batteries only AFTER charging.
• Use only the equipment provided in the Cruise Car SPWS Refill Kit (CCI P/N 102958001) to water batteries
with the SPWS.
WATERING BATTERIES WITH THE SPWS
Checking the Water Flow Rate
1. Connect the water hose with the built-in screen filter (2) to the water faucet (1) (Figure 33). See following CAUTION.
CAUTION
• Make sure the screen filter is clean.
• Do not use a longer garden hose than provided with the System (20 feet), as a decrease in water pressure could
overfill the batteries and damage the refill system.
2. Before screwing the hose-end assembly (3) onto the opposite end of the water hose, check the screen filter (4) inside the
end of the assembly to make sure it is clean (Figure 33).
3. Connect the purger (5) to the female coupler (8) on the hose-end assembly (Figure 34).
4. Completely open the water faucet until the water flows out of the hose-end assembly (3), and note the movement of the
red flow indicator balls (6). See following NOTE
NOTE: The water flow rate must be at least two gallons-per-minute for the SPWS to function properly This step also
eliminates any trapped air from the water hose.
5. After ensuring adequate water flow rate, press the grey button (7) on the end of the female coupler (8) to disconnect
the purger from the pressure regulator.
Refilling the Batteries
To Next Page
Loading...