44
1. Locate the battery fill coupling (9) on the driver side of the battery compartment, remove the dust cover (10) from
the male connector (Figure 35), and connect the hose-end assembly (3) (Figure 36). The water flow will begin
immediately
2. The red flow indicator balls should swirl, indicating that the batteries are being filled. See following CAUTION.
CAUTION
• If at any time water overflows from the batteries, immediately stop the refill process, disconnect the
pressure regulator from the battery fill coupling, and call for service.
3. When the red flow indicator balls stop moving, immediately press the grey button to disconnect the hose-end
assembly from the battery fill coupling (9), and squeeze the dust cover (10) to lightly secure it to the male connector
of the battery fill coupling (Figure 35).
4. Place the battery fill coupling into the space between the battery bucket and the car body. Leaving the fill coupling
on top of the battery bank or tucked between the batteries and the battery bucket can result in coupling damage.
5. Turn the water faucet off when finished filling the vehicle(s).
To Next Page
Loading...
