9
• Upper Section: This section consists of a button called “Manual” and six buttons
called “Presets.” These buttons control the sound settings related to the upper
manual drawbars found directly under the upper manual preset buttons.
“Manual” – When the “Manual” button is selected, all nine drawbars can be used in
real time to adjust the sound. This setting also allows for the addition of percussion
to the sound. Any drawbar settings created when using the “Manual” setting can be
saved to one of the six presets. “Presets 1-6” – These buttons operate like the
preset keys on an original tonewheel organ. Drawbar settings created when the
organ is set to “Manual” can be saved to one of these presets. When using a preset,
the drawbars are not active. Additionally, percussion cannot be enabled or saved in
a preset.
To create a preset, select the “Manual” setting and adjust the drawbars. Press and
hold any of the six preset buttons for five seconds. Any saved presets remain in the
memory of the instrument when the instrument is powered off.
• Lower Section: This section consists of a button called “Manual” and six buttons
called “Presets.” These buttons control the sound settings related to the lower
manual drawbars found directly under the lower manual preset buttons. Preset
storage operates the same as on the Upper manual. Percussion cannot be enabled
on the lower manual.
• Vibrato Section: This section controls the vibrato/chorus function of the instrument.
The vibrato/chorus effect can be added to the upper and lower manuals
independently with the “Up” and “Lo” buttons.
Varying degrees of vibrato/chorus can be selected with the “Vib/Cho” button.
Pressing the button repeatedly changes the setting. An LED lights up next to the
current selection. The same setting affects both manuals simultaneously.
• Percussion Section: This section controls the percussion function of the
instrument. Percussion can be added to the Upper manual when the instrument is
using the “Manual” setting.
• “On” – Turns the percussion on or off for the Upper manual.
• “Soft” – Sets the percussion at a lower volume when enabled.
• “Fast” – Sets the decay rate of the percussion effect. When enabled, the
percussion decays quickly. When disabled, the percussion decays at a slower
rate.
• “3
rd
” – Sets the percussion harmonic. When enabled, the percussion harmonic is
set to a 3
rd
. When disabled, the harmonic is set to a 2
nd
.
PLEASE NOTE: LIKE THE ORIGINAL ORGAN, PERCUSSION CANNOT BE SAVED
IN A PRESET AND USING PERCUSSION WILL DISABLE 1’ DRAWBAR OF
UPPER.
To Next Page
Loading...
