Need help?Do you have a question about the Crunch Blackmaxx MXB-4100 and is the answer not in the manual?
Steps for mounting the amplifier securely using provided screws.
Details on grounding, remote turn-on, and battery connections for amplifier.
Controls for high-pass, low-pass filters, and crossover points.
Adjusts input sensitivity and bass enhancement.
Ports for connecting audio sources and other amplifiers.
Displays power status and protection circuit activity.
Controls for high-pass, low-pass filters, and crossover points.
Allows selection between 2 or 4 channel operation modes.
Adjusts input sensitivity and bass enhancement.
Ports for connecting audio sources and other amplifiers.
Displays power status and protection circuit activity.
Setup for using a 2-channel amplifier in stereo configuration.
Setup for using a 2-channel amplifier for a subwoofer.
Setup for a 4-channel amp driving front and rear speakers.
Setup for a 4-channel amp driving two subwoofers in mono.
Setup for a 4-channel amp in 3-channel mode for front speakers and subwoofer.
Setup combining a 4-channel amp for speakers and a 2-channel amp for subwoofer.
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 100W x 4 |
| THD at Rated RMS Power | <0.05% |
| Signal to Noise Ratio | >90 dB |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Frequency Response | 10 Hz - 22 kHz |
| Bass Boost | 0-12dB |
| Bass Boost Frequency | 45 Hz |
| Bridgeable | Yes |
| Fuse Rating | 30A |
To Next Page