Crusader Pro - System Troubleshooting - Salt and Refill Issues; System Uses Too Much Salt Causes and Solutions; Salty Water to Service Causes and Solutions; System Fails to Refill Brine Tank Causes and Solutions

To Next Page

To Previous Page

Page 36

System Uses too Much Salt

Salty Water to Service

System Fails to Rell Brine Tank

Cause Solution

Excessive water in brine tank Refer to problem “Excessive water in brine tank”

System cleaning frequently

Check household for excessive or unexpected

water usage -- leaky toilet ll valves, T&P relief

drainage, Reverse Osmosis processors, humidi-

ers, plumbling leaks, etc.

Cause Solution

Excessive water in brine tank Refer to problem “Excessive water in brine tank”

Injector undersized Verify injector selection

Injector fouled Remove and clean injector

Improper brine/slow rinse time setting

Verify that brine/slow rinse time corresponds to

the proper salt level and amount of resin

Improper fast rinse time setting

Verify that fast rinse time corresponds to the

proper salt level and amount of resin

Cause Solution

Improper brine rell time setting

Verify that rell time corresponds to salt level

and amount of resin

Plugged rell ow control Clean ow control

System Troubleshooting Guidelines

Crusader Pro, Deluxe, & Enhanced Systems Owner’s Manual 2020