MODEL 2740
GENERAL INSTRUCTIONS
1. Read all instructions.
2. Always wear PPE. Take precaution and wear thermally protective equipment that is suitable
for wet environments. This machine is preset to 130F. The liquid will be hot. Most surfaces
will be hot. All parts removed from the machine will be hot.
3. Do not operate equipment with a damaged cord or if the equipment has been dropped or
damaged until it has been examined by a qualified technician.
4. Do not let cord hang over edges of table, bench or counter or come in contact with hot
manifolds or moving fan blades.
5. If an extension cord is necessary, a cord with a current rating equal to or more than that of
the equipment should be used. Cords rated for less current than the equipment may
overheat. Care should be taken to arrange the cord so that it will not be tripped over or
pulled.
6. Always unplug equipment from electrical outlet when not in use or empty. Never use the
cord to pull the plug from the outlet. Grasp plug and pull to disconnect power to the unit
before maintenance or servicing of the equipment.
7. Wait for at least 15 seconds before opening Lid/Sink after washer has timed off.
8. To reduce the risk of fire, do not operate equipment in the vicinity of open containers of
flammable liquids (gasoline).
9. Keep hair, loose clothing, fingers, and all parts of the body away from moving parts.
10. To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
11. Use only as described in this manual. Use only manufacturer’s recommended attachments.
12. The ambient air temperature should not be below 40F or above 105F.
13. Do NOT modify these machines.
“SAVE THESE INSTRUCTIONS”
3
Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948
To Next Page
Loading...