MODEL 2740
SAFETY INSTRUCTIONS
DANGER! This is a HEATED device. This equipment is designed for use only with Aqueous
Based Solutions. Do NOT add any other chemicals to the cleaning agent including,
but not limited to: mineral spirits, kerosene, fuel oil, gasoline, or chlorinated
solutions. The use of any other solutions could potentially cause a hazardous
condition including risk of fire or explosion.
DANGER! NEVER operate electrical equipment inside of parts cleaner.
DANGER! This machine utilizes HIGH VOLTAGE 220V 1 Phase electricity. ALWAYS disconnect
power to the unit before removal of the electrical panel cover. Obtain the services
of a qualified electrician for all electrical work.
Make sure the parts cleaner is connected to a properly grounded power source.
Check serial plate for power requirements.
WARNING! Avoid contact with eyes or skin. Wear protective eyewear, gloves, and clothing.
Operation should be conducted in a manner, which prevents splashing, or spillage.
Any spills should be promptly and properly cleaned up. Soak up all spills with
absorbent material. Remove and dispose of all soaked material in accordance with
regulatory requirements.
CAUTION! Do NOT allow heater to operate unattended for long periods, such as evenings or
weekends.
CAUTION! This machine comes with a built-in lid limit switch to protect the operator from
injury. In the event that the lid is lifted mid-cycle, the limit switch will cease all
operation of the turntable and pump.
NEVER Modify or defeat the limit switch. An unsafe condition may occur if any
unauthorized changes are made.
4
Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948
To Next Page
Loading...