MODEL 2740
CONSIDERATIONS
1. Make sure the site is level and smooth
2. The floor surface needs to be appropriate for supporting the weight and applied pressure
of the unit.
3. Plan space around the unit to allow access for maintenance, service, and repair. Refer to
the clearance dimensions above as recommendations.
4. Plan space above the unit to allow the lid to fully open and close without interference.
Refer to the open lid height in the above dimensions.
5. The unit typically creates a significant amount of steam. Make sure this steam will have
no adverse effects on the surrounding area.
6. The process of removing wet parts from the machine will inevitable result in some water
or solution spilling on the floor. Consider traction mats around the machine and avoid
placing the machine next to a walkway.
ELECTRICAL SPECIFICATIONS
ELECTRICAL HOOK-UP
The 2740 comes fully wired with plug in the 6-50P configuration. The voltage, phase, and
current draw of the machine are listed above and on the serial number plate. The wiring
diagram is listed below in this manual.
6
Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948
System:
Voltage: 220VAC
Phase: 1PH
Amperage: 24A
Largest Motor:
HP: 3/4HP
Wattage: 550W
FLA: 6.5A
To Next Page
Loading...