MODEL 2740
OPERATING INSTRUCTIONS
IMPORTANT DO NOT USE EXTENSION CORDS.
FILLING AND USING CLEANING COMPOUND
1. Do not plug in the Parts Washer until it has been filled with water. Damage to Pump Seal will occur if
the Pump Motor is turned on with no water in the reservoir. The water level marker ( FULL ) is on the
inside back wall located under the basket..
CLEANING RESERVOIR
1. Do not let Parts Washer get over contaminated. If solids cover the heater it can burn out. The spray
manifold can over build with scale and residue that will reduce flow.
2. Remove caps on end of spray manifolds, use a pick or drill bit by hand to clean out spray holes, close
Parts Washer lid, turn pump on for 2 seconds, replace caps hand tight.
3. Make sure the cord is unplugged before draining reservoir.
4. Remove the large basket, basket support and pump screen. After cleaning is complete, clean pump
screen and place it back in position. Grease top of spindle and place basket support and basket back
in position.
5. Clean out dirty solution, when the solution is down to the bottom,. Clean and rinse out the bottom of
reservoir.
6. Take care in cleaning around the heating element and low water float switch.
7. Clean the float switch thoroughly wiping it of all grease and metal filings.
8. Fill with chemistry, allow heat up time.
FOAMING
1. Foaming can be caused by many different reasons such as, cold bath temperature, lack
of cleaning compound from use, extreme amounts of certain greases or gear oil, too long of a service
interval, over contaminated bath, and over time the salts from water that is added to the bath.
7
Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948
To Next Page
Loading...