THANK YOU FOR BUYING A CRYSTAL MOUNTAIN WATER COOLER!
RECEIVING
Inspect the cooler box immediately and carefully for any evidence of shipping or handing
damage before signing to receive goods. In case of shipping damage, claims should be filed
immediately with the carrier. Please note that the carrier will not accept claims for any damage
discovered after the signing for UNINSPECTED GOODS. Ensure cooler stands upright for 24
hours before plugging it in.
OPERATION
1. Place the water cooler on a flat level surface in a cool shaded location near a grounded wall
outlet. Position water dispenser so that the back of the unit is a minimum of 2 inches / 5cm
away from the wall to ensure proper ventilation.(Figure 1)
2. Place the water bottle on top of the cooler appropriately. For open reservoir models, the
bottle cap needs to be removed.(Figure 2)
3. Ensure that the available power supply matches the cooler’s voltage specifications indicated
on the nameplate label (located at the rear of unit). Plug power supply cord into receptacle
(Figure 4).Please ensure that cooler is set up so as access to the power outlet and plug is
unobstructed.
4. Do not draw water from the cooler for about 30 minutes to let the water cool or heat.
Optimum water temperatures will be reached after several hours of operation. (Figure 5 and
Figure 6)
Note: On H&C models, vent the hot tank by holding the red faucet open until water flows out.
(Heater switch (Figure 3) may now be turned on)
Note: To provide additional protection from the risk of shock, this unit MUST be connected
to a ground fault circuit interrupter (GFCI) outlet at all times. Use of an extension cord will
void any warranties.
Figure 5 Figure 6Figure 4
Figure 1 Figure 2
To Next Page
Loading...