Bulaşık Yıkama Makineleri - Professional Dishwashers
Montaj ve Kullanım Kılavuzu - Installation and User's Guide
27
If we explain the numbered sections (for CRW 500 and CRW 400):
1. Closed position of the device.
2. Short program position.
3. Long program position.
4. Location of the drain.
5. Signal lamp indicating the completion of the water heating.
6. Showing the signal light into electrical energy machine.
7. Wash cycle start button. When in drain mode, this switch must be
pressed until full drainage.
8. Signal lamp showing that Rinse or wash program is running
Use of device:
Because your device is designed to operate serially, switch off the device (1) in
case you don’t use device long term (for example end of the day).
Before start to use device, wait awhile for resistance to heat water before first
dishwashing. The heating time of device that is complete cold or newly taken
water takes approximately 30-45 minutes. You must switch button of device to
(2) or (3) in order to start heating. When heating is completed, no (5) green signal
lamp illuminates, inform you that device is ready for use.
In order to use device of which heating is completed, put basket inside device and
close door. The dishwashing is started according to the program you select when
you close the door (for CRW 1000 only). For CRW 500 and CRW 400 models, in
order to start wash cycle the switch (7) must be pressed. The rinsing automatically
starts after dishwashing following 5 seconds of waiting time. When door is
opened at the moment of dishwashing, the dishwashing automatically stops, and
To Next Page
Loading...