Remark: - Pl refer to programming / user section to activate these function’s
Caution: -All System Programming can be done only in Main Password mode from any Extn. in
tone / DTMF mode at the site.
(1) INTERCOM Call: To make an internal call (Extension To Extension)
❖ If you get busy tone (i.e. the dialed extn is busy), hang up & try again later or use the “Auto Call Back” function .
(2) TRUNK / JN CALL :To make an outside call via particular Junction line (L1 means line 1, L2 means line 2……onwards)
or via Random access Junction Group number 0/5.
❖ If you get Busy tone after dialing JN access code, hang up & try again later or use the “Auto Call Back” function .
❖ If you get Error Tone that means your extension is locked for OUTGOGING calls.
❖ In default mode all Jn. Lines are programmed in “0” group
(3) LAST NO. REDIAL: To redial last external dialed out number
❖ Do not use “REDIAL” key of your phone to redial the last dialed external number.
(4) ANSWERING / RECEIVING CALLS: To answer a call
78 + 1/2/3/4
(Duration, One, Daily, Remote)
To Next Page
Loading...