Note- Default Delay time is 3 Sec.
(19) HOTLINE FUNCTION: To do operate pre-defined any one Hotline function (1/2/3)
(20) CONFERENCE (THREE PARTIES): You can have a conference between yourself and other two parties (either extn. or Jn.).
To initiate a conference, proceed as follows with different options –
1) All three intercom, 2) Two intercom& one JN call, 3) Two JN call & one intercom
When the master extension which had originated conference goes On-Hook, conference will be terminated.
NOTE: While adding extensions/ junction., you may get
A) Busy Tone – Dial Flash + 2 and re-start the process.
B) Error Tone – Dial Flash + 2 and re-start the process.
C) No-Reply–Dial Flash + 2 and re-start the process.
(21) DAY/NIGHT/LUNCH MODE: To set for Lunch / day / night / auto , landing modes for incoming call
Dial 16 + 2 + XX (Junction No.) + Y (Delay Time)
XX= L1 =01,L2 = 02….., Y= 1 to 9 sec
Dial 16 + 3 + XX (Extension No.) + Y (Delay Time)
XX= 201,202,203….., Y= 1 to 9 sec
Wait for automatic dial as program function (1/2/3)
Start conversation when set caller reply
Hang up, when after conversation
Lift handset& Dial 160,Get confirmation tone
Press Flash Key, to put Extension / Jn. On hold
Music tone to held
extension/Jn
Dial 2
nd
Extension / Jn number
When extension answer’s,
Press Flash Key & Dial “ 0 “
Three party conference is established
Hang up, when conversation is over
Dial self password (xxxx)
Dial 85 + 0 / 1 / 2 for Manual Mode
0= Lunch, 1= day & 2= night mode
Dial 85 + 3 for Automatic Mode