(19) DYNAMIC LOCK : An extension can use dynamic lock to protect misuse of outgoing trunk call's from
his extn. To do so:
(A) TO SET DYNAMIC LOCK
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *81 + self password (xxxx) confirmation tone Default XXXX is 1111
3 Hang up
(B) TO OPEN DYNAMIC LOCK
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *82 + self password (xxxx) Confirmation tone Default XXXX is 1111
3 Hang up
(C) TO CHANGE SELF PASSWORD
Dial *86 + XXXX + ZZZZ XXXX = Old self password ZZZZ = New self Password
(20) HOTLINE EXTN. / JN.: You can use hotline, when a particular extension/jn is to be used repeatedly.To do so
Step Procedure Tones Abbreviations
1 Lift Hand set Internal Dial Tone
2 Dial *161 + XX Confirmation Tone XX = Extension Number /Junction no.
Note- Refer programming manual to set delay timer for HOTLINE. Default time is 3 Sec.
Cancellation of Hotline Lift handset & Dial *160,Get confirmation tone
(21) HOTLINE FUNCTION:
Step Procedure Tones Abbreviations
1 Lift hand set Internal Dial Tone
2 Wait for automatic dial of extn / Jn number Ring back/ Jn tone
3 Start talking when set extension answers
or dial outside no. after Jn. Dial tone
4 Hang up, when conversation is over
(22) ALARM :
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
A One Time Alarm (ring at specified time)
Dial *982+HHMM Confirmation tone HHMM = 24 Hr format
B Repeat Alarm (ring daily at specified time) Confirmation tone X = 3 1ST Alarm,4 2ND Alarm,
Dial *98+ X+HHMM 5 3rd Alarm
Note :- Your extension shall now ring daily at this time specified time till it is not cancelled.
To cancel all alarm's Dial *980
Inspire 104/206/308/414 User Guide
8
To Next Page
Loading...