(23) RELAY PORT : The relay port can be used manually or set for pre-programmed timings to switch on/off any
electrical appliance.
Caution: - If the electrical appliance consumes less than 0.5 amp. of current (i.e. - 100 watt ) ,you can drive it
directly, and if it consumes more, you can drive it through an external relay/contactor.
Note : To set for auto operation of the relay, pl refer to the programming section.
(A) MANUAL OPERATION : To operate any electric gadget
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *165 for relay ON Confirmation tone
3 Dial *166 for relay OFF Confirmation tone
4 Hang up
(B) CLICK OPERATION : To operate any electronic door lock
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *167 for relay click Confirmation tone
3 Hang up
(24) PAGING : Audio Amplifier of public address system can be connected to the paging port
(optional attachment required ). You can make an announcement directly as follows
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *87+X Confirmation tone X = 1 active paging function
(25) TRUNK RESERVATION :You can reserve the particular trunk line for pre-defiend time to make outgoing
calls. To do so:
Step Procedure Tones Abbreviations
1 Lift the handset Internal Dial Tone
2 Dial *112 + X (Trunk No.) Confirmation Tone X =Trunk No., 1/2/3/4
i.e. line 61/62/63/64
3 Hang up
Cancellation of Trunk Reservation Lift handset & Dial *1120, Get confirmation tone
Inspire 104/206/308/414 User Guide
9
(26) EMERGENCY DIAL AT FND : Any extension can dial emergency code. Now display will show intercom
extension no.with buzzer beep. Normally FND show date / time in ideal
condition. Use following procedure:
Step Procedure Tones Abbreviations
1 Lift the handset Internal Dial Tone
2 Dial *99 Ring Back Tone Show extn. no. & buzzer beep at FND
Now you can attend directly to emergency caller .
To cancel of FND status Dial *77+Self Extension No.
Note :- To set for click action timer, please refer programming manual.
Note :- To set for reservation timer, Please refer programming manual.
To Next Page
Loading...