(27) FND ACCESS : You can install max. 4 no. FND (Front no. Display ) with inspire 308 & 414 model EPABX to
see Intercom number. When any extension dial particular number of display, it will show caller
no. as well as buzzer beep for ten sec.
Step Procedure Tones Abbreviations
1 Lift the handset Internal Dial Tone
2 Dial 21 Ring Back Tone Show extn. no. & buzzer beep at 1st FND
OR
3 Dial 22 Ring Back Tone Show extn. no. & buzzer beep at 2nd FND
OR
4 Dial 23 Ring Back Tone Show extn. no. & buzzer beep at 3th FND
OR
5 Dial 24 Ring Back Tone Show extn. no. & buzzer beep at 4th FND
Inspire 104/206/308/414 User Guide
10
(29) REMOTE MAINTENANCE : Easy way to program the system as per need of user from the remote location.
Service engineer can program over phone line without presence at user place .
Use below procedure for remote program:
(1) Establish a call ( Via incoming / outgoing) with user through trunk line &
start conversation at any extension.
(2) User will put service engg. on hold by hook flash -- Get music tone on hold
(3) After hook flash dial *399 by user. Now both will be come back on
conversation mode
(4) Now any one can dial system password to do programing and get
beep beep tone.
(5) Start programing by service engg.
(6) Get assurance tone on each correct program other wise get error tone
(7) Continue the program after each correct steps.
(8) To exit from programing mode dial 0
Note :- (1) Programing can be done only in DTMF mode.
(2) The service engg. and user at extension can talk during the remote programing
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial any one memory location Particular memory location will be
*8800 to *8899 dialed out
Note :- Refer programming manual to set Global Memory Location.
(28) GLOBAL MEMORY DIALING : 100 no of Central Memory Pool (*8800 to *8899) for external call can be
commonly accessed by all extensions. Each stored no. can be max. 16 di gits
(including STD/ISD codes and external no.)
To Next Page
Loading...