21
M
M
WARNING : This operation is used to assist servicing and future repairs.
The default settings should only be modified by an experienced professional person.
4.
Use
4.9
System parameter query
WARNING : Any change to the reserved settings will automatically void the warranty.
The system’s settings can be checked and adjusted via the remote control by following these steps
Step 1 : Keep pressing 3s on until you enter the settings verification
mode.
Step 2 : Press and for see the configured parameters.
Step 3 : Press to select the setting to be modified, the value is blinking.
Step 4 : Press and to adjust the setting value.
Step 5 : Press to set the new value.
Step 6 : Press
to return to the main screen.
If not operation for 10s, it will be exited automatically.
To Next Page
Loading...