Programming Manual xiv
Chapter 6: OmniSTAR Commands - describes the commands accepted by
the internal OmniSTAR receiver. Only the DGPS MAX supports
OmniSTAR.
Chapter 7: Beacon Commands - defines the commands supported by the
internal beacon sensor. The receivers that support beacon are: DGPS MAX,
Mini MAX, PowerMAX, Vector PRO, Vector Sensor PRO and Vector OEM
PRO.
Chapter 8: Heading Commands – defines the commands supported by the
heading systems. The heading systems are: the Vector, the Vector PRO, the
Vector Sensor, Vector Sensor PRO and the Vector OEM.
Chapter 9: e-Dif Commands - defines the commands supported by the
internal e-Dif software. Only the Mini MAX (including the SX-1), the
PowerMAX, and the DGPS MAX support e-Dif.
Chapter 10: Binary Data – defines the commands that can be sent in binary
format which can help to improve efficiency or provide information that
cannot be accessed through other formats.
Chapter 11: Menu System Commands - describes the commands used to
configure the setup of the DGPS MAX’s menu system.
Chapter 12: Configuration Wizard - provides a discussion of the commands
used to define configurations for DGPS MAX operation.
Chapter 13: Frequently Asked Questions - This chapter provides answers
to frequently asked questions about programming the DGPS MAX, the Mini
MAX, the PowerMAX and the Vector products.
Appendix A - Resources: This appendix lists resources that may be useful
for the advanced user.
The Further Reading section provides a listing of GPS/DGPS sources for
further information.
To Next Page
Loading...
Need help?
General
