7. Beacon Commands (for all
receivers excluding Vector and
Vector Sensor)
This section details the commands supported by the DGPS MAX, Mini MAX,
PowerMAX, Vector PRO, Vector Sensor PRO and Vector OEM PRO’s
internal SBX beacon engine.
The following table provides a brief description of the commands supported
by this engine for control of its configuration and operation.
Table 7-1 Beacon Commands
Message Description
$JASC,BEAC This command instructs the receiver to output beacon RTCM data when in beacon mode
$GPMSK You may use this message to manually or automatically tune the beacon receiver
$PCSI,0 This command allows you to request a listing of available beacon commands
$PCSI,1 Issuing this query will cause the beacon receiver to return a channel 0 status message
$PCSI,2 Issuing this query will cause the beacon receiver to return a channel 1 status message
$PCSI,3 This command polls the beacon receiver for its search data
$PCSI,4 This command is used to erase automatic search data, forcing a new search to begin
$GPCRQ This query allows you to request either signal status or frequency status data
$CRMSS This message provides signal status data
$CRMSK This message provides frequency status data
The following subsections provide detailed information relating to the use of
each command.
Note - The beacon receiver does not require a save command in
order to maintain its settings. Changes to its configuration are
automatically saved to memory.
To Next Page
Loading...
Need help?
General
