$>JSHOW,BAUD,9600 (1)
$>JSHOW,BAUD,9600,OTHER (2)
$>JSHOW,ASC,GPGGA,1.0,OTHER (3)
$>JSHOW,ASC,GPVTG,1.0,OTHER (4)
$>JSHOW,ASC,GPGSV,1.0,OTHER (5)
$>JSHOW,ASC,GPGST,1.0,OTHER (6)
$>JSHOW,ASC,D1,1,OTHER (7)
$>JSHOW,DIFF,WAAS (8)
$>JSHOW,ALT,NEVER (9)
$>JSHOW,LIMIT,10.0 (10)
$>JSHOW,MASK,5 (11)
$>JSHOW,POS,51.0,-114.0 (12)
$>JSHOW,AIR,AUTO,OFF (13)
$>JSHOW,FREQ,1575.4200,250 (14)
$>JSHOW,AGE,1800 (15)
This example response is summarized in the following table.
Line Description
1 This line indicates that the current port is set to a baud rate of 9600
2 This line indicates that the other port is set to a baud rate of 9600
3 This line indicates that GPGGA is output at a rate of 1 Hz from the other port
4 This line indicates that GPVTG is output at a rate of 1 Hz from the other port
5 This line indicates that the GPGSV is output at a rate of 1 Hz from the other port
6 This line indicates that GPGST is output at a rate of 1 Hz from the other port
7 This line indicates that D1 is output at a rate of 1 Hz from the other port
8 This line indicates that the current differential mode is WAAS
9 This line indicates the status of the altitude aiding feature
10 This line indicates the threshold of estimated differential performance that allows
the green DGPS LED to illuminate (on the Mini MAX only)
11 This line indicates the current elevation mask cutoff angle, in degrees
12 This line indicates the current seed position used for startup, in decimal degrees
13 This line indicates the current status of the AIR mode
14 This line indicates the current frequency of the L-band receiver
15 This line indicates the current maximum acceptable differential age in seconds
To Next Page
Loading...
Need help?
General
