CSN S.A.T. User Manual

While Tracking
While tracking the page will automatically update about every 2 seconds. The S.A.T. will automatically
determine if it should flip the antenna to track the satellite continuously through it's pass. (REVERSE)
will be displayed in the antenna position line to indicate this.
The maps and graphs will also start updating. Click anywhere on a map or graph to switch to the next
display type. Radio tips
Connection GPredict, etc
Using your Radio
* If your radio supports both VFO mode and SATELLITE mode, always use VFO mode. Do not use
SATELLITE mode on your radio. For the Icom 9700, and radios that support it, display both VFOs on
the screen at the same time. The red TX icon will be above the top VFO. If the red TX icon is on the
bottom VFO then you are in satellite mode and you should change to VFO mode.
Some radios have a spectrum scope. If you wish to see the received signals on the scope be sure to
attach the scode to the receive VFO. (See radio manual for instructions)

CSN S.A.T. Specifications

General

Brand	CSN
Model	S.A.T.
Category	Controller
Language	English