CSO sirius+ - Troubleshooting Common Issues

INSTRUCTIONS FOR USE
sirius+ | IFU327EN00 - 01/2021
This document is the property of
CSO Costruzione Strumenti Oftalmici srl.
Any reproduction, even partial, it is prohibited.
52/56
5.2.4 CLEANING THE APPLIED PARTS
CAUTION
Danger of
material damages. Only use detergent and disinfecting
products specifically approved for medical devices or medical-
surgical devices.
Applied parts that come into direct contact with the patient during
the examination shall be thoroughly cleaned after
each use with a
disinfectant approved for the purpose.
1
Turn off the device and unplug it from the electrical outlet.
2
Clean the applied parts using products suitable for surface
disinfection (they may contain aldehyde).
Alternatively, use a non-abrasive cloth soaked in a solution of
water, ethyl alcohol (70% maximum) or isopropyl alcohol.
For more information about suitable cleansing products, read the
“Recommended products for cleaning and disinfection
” paragraph
on page 49.
5.2.5 CLEANING THE OPTICAL COMPONENTS
CAUTION
Danger of material damages. The device is equipped with optical
components
. The optical components of the device are precision
and pressure sensitive parts. Clean using a non-
abrasive cloth to
avoid damaging the surface.
Clean the optical components carefully using a dry, non-abrasive, lint-
free cloth.
5.3 DEVICE CALIBRATION
Perform device calibration periodically, in order to ensure accurate
measurements. Follow the calibration instructions given in paragraph
“How to perform device calibration” on page 39.