CTEK MXS 5.0 Faq

3
Does my charger have a 'RECOND' program?
YES - It is a mode that is used for reviving deeply discharged batteries, breaking down
sulphation and reversing acid stratification. It requires a manual selection from the user and
will add an extra step to the charge cycle, It uses a voltage of up to 15.8v to deliberately gas
the battery in a controlled way in order to re-mix the acid to get an optimized acid balance
(acid weight). This mode is also recommended for Ca/Ca batteries which require the higher
voltage when charging.
What do the program symbols on my charger
mean?
MC = 14.4V / 0.8A for batteries 1.2 -14 Ah
CAR = 14.4V/ Charger output (e.g., MXS 5.0 is 4.3A)
SNOWFLAKE/AGM (MXS 5.0) = 14.7V
SUPPLY = 13.6V/ up to a max charger output (e.g., Multi US 7002 = 7A)
'SNOWFLAKE' can be used on batteries when temperature drops under +5
O
C.
Can I use my CTEK charger with a start/stop
vehicle?
Yes. CTEK chargers are safe to use on start/stop vehicles.
Do I have a charger or a maintainer (trickle)?
The CTEK unit is both charger and a maintainer.
The maintenance mode will apply automatically after the battery is fully charged.
Can I charge while the battery is being used?
Yes. But simultaneous consumption or parallel load will prolong charging time.
(The consumption cannot exceed the output of the charger e.g., MXS5.0 the load cannot exceed
4.3A).
What accessories do I need to start charging?
The accessories required to start charging are supplied with the charger. There are a wide range of
consumer accessories on the web site to enhance your charging experience.

CTEK MXS 5.0 Specifications

General

Input voltage	220-240 V
Input frequency	50/60 Hz
Battery voltage	2 V
Cable color	Black
Operating temperature (T-T)	-20 - 50 °C
Number of batteries supported	-
Product color	Black, Silver

Weight and Dimensions

Depth	168 mm
Width	65 mm
Height	38 mm
Weight	600 g