EasyManuals Logo

CTEK MXS 7.0 Troubleshooting Guide

CTEK MXS 7.0
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Trouble Shooting Guide 13
Explanation 5: The charge cycle is interrupted in step 2.
Test: Test to restart the charge cycle with the mode button, if it still fails in step
2 the battery is can’t be charged and needs to be replaced.
Explanation 6: The charge cycle is interrupted in step 5.
Explanation 6.1: Large loads are connected to the battery and drain the
voltage.
Test: Disconnect the loads and try charging again.
Explanation 6.2: The battery cannot retain the charge provided.
Temperature LED is lit
Explanation: This led is turned on automatically when the temp sensor is
connected.
Temperature LED is not lit
Explanation: The temperature sensor is disconnected or has been damaged.
The charger will assume room temperature and charge without temperature
compensation.
Temperature LED is flashing
Explanation: The temperature is above + 65 °C. The current is reduced until
the temperature has dropped below + 65 °C. The charger reverts to normal
charging current when the temperature drops below + 65 °C.

Other manuals for CTEK MXS 7.0

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CTEK MXS 7.0 and is the answer not in the manual?

CTEK MXS 7.0 Specifications

General IconGeneral
Input voltage220-240 V
Input frequency50/60 Hz
Battery voltage2 V
Cable colorBlack, Red
Operating temperature (T-T)-20 - 50 °C
Number of batteries supported-
Product colorBlack, Silver
Weight and Dimensions IconWeight and Dimensions
Depth191 mm
Width89 mm
Height48 mm
Weight800 g

Related product manuals